Non-fat dried milk (NFDM) is suitable for short and long term emergency food storage. It is made from non-fat, grade A, milk that has been dried by spraying into hot air or heated on a drum. The process removes nearly all of the water prohibiting the grow
These advertising-free forums are provided free of charge through donations from Society members. Anyone may read the forums, but to post you must create a free account.
I would prefer those fittings to have internal Este rings and knurled thread on ports (similar to R134a vacuum gauge sets) that do not require high torque compression fittings. Finger tight and you are good to go. You spot a leak, change the Este ring and you're back in business.
The best places to buy a commercial freeze dryers in person are either directly from the physical stores of the manufacturers, or in person at various appliance stores, which are usually authorized resellers of freeze dryers.
We have two freezers in the garage as well. All of these machines generate heat and humidity. Our FDer front regularly sweats up an storm and water drips off the door and from around the entire chamber perimeter down the front of the unit. It got so bad that I taped a plastic shield above the display to route the water around it. You can see the water on the door and on the stainless steel front past the 4 screws on the unit.
So I corrected the oversight - I drilled and tapped the elbow to add the port. Here is a picture. It worked great today when I flushed the pump to clear out the gunk.
I removed the side covers and found the water dripping from the chamber insulation. I called up HarvestRight to ask for ideas on how to avoid this in the future.
7) Next up the drain line. This not only deminishes condensation but also eliminates an unnecessary hot spot into the chamber.
Let's do a simple math exercise. Non Frozen food put in freeze dryer at an ambient temp of 70F needs to be at -40F before the dry cycle begins. things go linear, each hour the temps would drop the food by 12.
5 Posted September 16, 2015 (edited) Gypsyman: Proof again that "great minds think alike". In my initial pondering, I thought using an oil filter base would be a logical approach -- but I didn't have one handy and figured my car might miss it. Besides, one of my goals was to keep this affordable, and they tend to be a little pricey.
When buying from resellers, those terms may change as they’re affected by the relationship between the manufacturer and the reseller.
and more info this piece was placed on the vacuum hose fitting. I can still remove the panel without removing the hose to clean the coils. Simply remove the screws and slide the panel down the vacuum hose a few inches.
Options: consumer choices for this appliance are currently limited. There are few companies making “home” freeze dryers, laboratory freeze dryers are built for scientific sampling so may not work as well for food, and the small commercial “pilot study” freeze dryers tend to be larger than those marketed for home use.
A couple of other points: There are obvious and easy improvements that could be made, such as using a container with a dispensing faucet (think of a lemonade jar, for example). Also, for the technically savvy, Automóvel-mechanic-type person who may be wondering about it, there is an anti-backflow seal that has to be removed from the oil filter, but that can be removed by cutting through it and pulling it out with needle nose pliers, which is easily done.